Harley Davidson Engine Light Comes On And Off

A backfire or spitback could have set the code.

Harley davidson engine light comes on and off. 1- Turn motorcycle ignition switch to OFF RunStop switch to RUN. Harley-Davidsons motorcycles come equipped with an oil pressure switch and a corresponding indicator light to provide the rider with a visual warning of a potential problem with the engines lubrication system. When it is an historical fault code it comes on with ignition and goes off then comes on and goes off again.

Background lighting should illuminate speedometer needle should sweep its full range and indicator lamps battery security low fuel check engine and cruise should illuminate. If there was a shortTo Ground on the WO would cause the Light to come on. To enter the diagnostic system and retrieve a trouble code hold down the trip reset button while turning the ignition from off to on.

3- Turn ignition switch to Ignition and release odometer reset button. ELECTRICAL SYSTEM Potential Number of Units Affected. Check with a Voltmeter 20v range WO wire.

That doesnt mean you shouldnt get it checked out. See if it changes. This can be something simple wrong or something more urgent that could strand you on the side of the road.

How to Pull Engine Codes From a Harley Davidson. I have a harley davidson 2000 dyna super guide and the engine light comes on and off time to time. This may seem silly but based on your post I had the same issue and it turned out to be the battery in my fob my bike ran but check engine light security light.

I bought the bike. I didnt get a check engine light though. After four seconds if it comes on again and stays on there is a present fault code.